Menu
Cart 0

DFRobot Gravity: Analogue Signal Isolator

  • $28.00AUD
  • Save $7AUD
  • (Exc. GST)


  • Available in stock

  • Shopify secure badge
  • $ We Ship Worldwide from AU (Perth), and Prices (AUD) are Exc. GST
  • $ We Offer Further Discounts for Resellers & Large Orders
  • $ We Accept Purchase Orders & Net30 Payment for Educational Institutes
  • DFRobot Gravity: Analog Signal Isolator

    The Analog Signal Isolator can isolate analogue signal and provide isolated power to sensors. It can effectively prevent sensor signal interference and apply to multi-parameter water quality monitoring sensors. Because usually sensors will be interfered by the other sensors during the measurement, especially those sensors in the water quality monitoring system. For example, pH sensor (pH meter) will be affected by the electrical conductivity sensor (EC meter). 
    The common solution is to isolate the power supply. Once you put them into the same container and share the same power supply, their value won’t be interfered by each other.This analogue signal isolator is designed for this situation, it will isolate the analogue signal and provide isolated power to the sensors. It has an on-board 5V isolated power IC, and compatible with Gravity-3Pin interface, plug and play, no need for soldering. The transform rate is 1:1, which means analogue values in two sides should remain the same.

    Gravity: Analog Signal Isolator Interface - DFRobot
    Gravity: Analog Signal Isolator Interface
    The isolator is compatible with almost all analog output sensors of many types produced by DFRobot.
    Caution:
    1.MCU should provide 5.0±0.1V power supply and it decides the finial output precision.
    2.The module will consume a large current when it is working, you’d better to use an external power supply. 
    3.The MAX output current of SEN terminal is 170mA.
    4.The GNDs of SEN and MCU are isolated, please DO NOT connect them together.
    5.It will be a little warm when it is working.

    SPECIFICATION

  • Operating Voltage: 5.0V
  • Response Time: 4 seconds (Typ)
  • Analog Error (both ends): <± 20mV (Typ)
  • Interface Type: PH2.0-3P
  • No load Current: 75mA
  • Dimension: 42 * 32mm / 1.65 * 1.26 inch
  • Non-isolated Terminal (Arduino Side)
    Supply Voltage: 5.0 ± 0.1V
    Analog Output: 0 ~ 5.0V
  • Isolated Terminal (Sensor Side)
    Output Voltage: 5.0 ± 0.2V
    Analog Input: 0 ~ 5.0V
  •  

    DOCUMENTS

    Schematic
    Layout
    Datasheet

     SHIPPING LIST

  • Gravity: Analog Signal Isolator x1
  • PH2.0-3P Cable x2

  • We Also Recommend

    Sale

    Unavailable

    Sold Out