Menu
Cart 0

DFRobot RS485 Shield for Arduino

  • $13.00AUD
  • Save $7AUD
  • (Exc. GST)


  • Available in stock

  • Shopify secure badge
  • $ We Ship Worldwide from AU (Perth), and Prices (AUD) are Exc. GST
  • $ We Offer Further Discounts for Resellers & Large Orders
  • $ We Accept Purchase Orders & Net30 Payment for Educational Institutes
  • DFRobot RS485 Shield for Arduino

    Arduino RS485 is an industrial standard for long distance, anti-interference, and reliable communication.   So we create this RS485 Arduino shield, specially designed for the Arduino controller board. It converts UART/Serial protocol to RS485 protocol.  This RS485 board allows Arduino access to industrial standard protocol easily.
    In contrast to RS-422, which has a single driver circuit which cannot be switched off, RS-485 drivers use three-state logic allowing individual transmitters to be deactivated. This allows RS-485 to implement linear bus topologies using only two wires. The equipment located along a set of RS-485 wires are interchangeably called nodes, stations or devices.
    • Integrated a standard RS485 port ,a mini RS485 port, RS485 headers
    • Provide the welding areas to make full use of the free space. And more importantly, it's convenient for your DIY design.
    • Switch between the automatic mode and manual transmission mode, which expands the scope of application.
    • Besides Tx/Rx interface, there is a switch to block/disable this shield, when Arduino needs to be programmed.
    • Gold immersion PCB. Long pins on the back adapt to most Arduino controllers.
    Arduino RS485 Shield Demo Project 1
    What is RS485?
    "RS-485 enables the configuration of inexpensive local networks and multi drop communications links. It offers data transmission speeds of 35 Mbit/s for distances up to 10 m and 100 kbit/s up to 1200 m. Since it uses a differential balanced line over twisted pair (like RS-422), it can span relatively large distances up to 1,200 m (4,000 ft). A rule of thumb is that the speed in bit/s multiplied by the length in meters should not exceed 108. Thus a 50-meter cable should not signal faster than 2 Mbit/s." From Wiki.

    SPECIFICATION

    • Power module: +5V
    • Module size: 55mmx53mm(2.16"x2.08")
    • 16 digital IO port (including an I2C interface)
    • 6 analog IO port and power
    • Operation and programming mode switch
    • Automatic and manual transceiver mode switch (When in manual transceiver mode, the enable end is the 2nd digital IO port)
    • Transceiver indicating LED
    • Standard RS485 interface, mini RS485 interface and RS485 pins
    • Welding area
    • Reset switch
    • PH2.0 sensor interface for DFRobot RS485 series sensor: URM04 Ultrasonic sensor 

    DOCUMENTS


    We Also Recommend

    Sale

    Unavailable

    Sold Out